Transformers Windblade’s Spear

$4.00

Description

 

Here’s our take on the Combiners Hunter Windblade’s spear.

This piece has been separated in 4 parts and can be assembled into a single spear or used as 2 individual maces. Assembly of the parts can be referenced from the attached image above.

It may be a good idea to print the middle piece first just to test the fit of the piece to your figure before you print the other parts which go onto it. If slight scaling is needed, you can apply the same scaling factor to all the parts.

Additionally, the full model is also included in the event that you would prefer to print it as a single part.

===

All rights for the original Transformers designs belong to Hasbro.

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios)

Support us on Patreon – https://www.patreon.com/FunbieStudios where this and other models are available.